Description Documents Description This is a plug for the PSS Shaft Seal hose barb. If your boat will not exceed 10 knots under power then the PSS Shaft Seal does not require positive water feed. The PSS Shaft Seal can simply be "vented" or you can use this plug in place of the hose barb that's inserted into the carbon stator. "Burping" The PSS Shaft Seal You will also be required to "burp" the PSS Shaft Seal whenever there is air trapped inside. Simply pull back on the carbon stator, separating it from the stainless steel rotor. This will cause a quick mist of water to spray out. Important If your boat will exceed 10 knots under power then it is required that a positive water supply be plumbed to the PSS Shaft Seal for the purpose of lubricating and cooling
PYI Inc. PSS Type B Shaft Seal
PYI Inc. PSS Type B Shaft Seal
GW Ping TiSI Adaptors-PSS - The GolfWorks
These T-Kits enable the installer to tee into the raw water discharge hose and plumb water to the hose barb fitting of the PSS Shaft Seal.
T-Kit
PYI PSS PRO Shaft Seals
PYI Inc Fisheries Supply
PSS Shaft Seal 1 1/2 Shaft & 2 1/4 Shaft Log/Stern Tube, 02-112-214, PYI Inc : Industrial & Scientific
Pss Shaft Seal 1- 1/2 Shaft 2- 1/2 Tube - Shaft Coupler
Mist-A-Pipe, Dual Nozzle Two Stage – ProMeth
PSS Shaft Seal 1 1/2 Shaft & 2 1/4 Shaft Log/Stern Tube, 02-112-214, PYI Inc : Industrial & Scientific
PSS Hose Barb Plug - PYI Inc.
PYI Inc. PSS Type C Shaft Seal
PSS installation instructions (low res).pdf - PYI Inc.
